ultra-osom-fast-reliable-easy-print-utopia
the artisan is a 3dprint blessing. -I have been testing for now up to 250mm/s with excellent quality. -i like the integration in luban, especially the separation of settings for application and settings for materials make a lot of sense, and settings are intuitive with a lot of helpfull descriptions. -accuracy of the printer is spot on. -feeding/calibration is intuitive and very good. -dual extrusion calibration is easy peacy -plenty more i am still learning as i am not a 3dprint-god... some of the (tiny) criticisms: -the startup procedure is ok, but could be improved by adding a restart or cancel button, personally i would not start this, but have a homescreen button somewhere to start this. -not sure why turning the printer off, is only possible with the powerbutton, and not on screen. -cable management is less than optimal: advise: reuse the straps to bind the cables together, and add tie-wraps to keep it tidy. and print something to easily detach it (but keeping cable management intact) from the external housing. the supplied clips aint doing enough. -luban does not always set the printer nozzles diameter when connecting to it, i was printing with 0.4 settings while i installed 0.6 nozzles (not sure how that is possible). -i would connect left+right filament holders with 1 bar to be able to hold 4 filament rolls. seems like a lot of negatives, but these are only slight/tiny things. overall impression of the printer is summarized in 1 word: ultra-osom-fast-reliable-easy-print-utopia.