only reviewing to tell the truth
only reviewing to tell the truth. all reviews made from this company come with the promise of a coupon resulting in inaccurate biased paid reviews. e5 has crooked belts in the rear ender 3 has belts that run into corners both sides. the ender 5 i received was a house fire out of box and, not up to code. all the wires going into the terminals were soldered. had i not checked vibrations or solder deforming in the terminal would have either fried the board or worse. any upgrades for these machines on their website are actually just fixes to pay for later. out of box yes they print after qc but only suited to slow speeds due to the engineering of the x axis being made of 3 pieces prone to pvioting and, misaligning overtime. always check the spacers some units have wide out of spec tolerances that mounts can shift on as a result as well.