I purchased a Ender3 v2 that arrived…
I purchased a Ender3 v2 that arrived 6/17/22. I had it assembled in a few hours. The next day I powered it up for the first time, flashing the firmware for the CRTouch. I ran a bedlevel check then leveled the bed manually. That worked better on my other printer. Ran the bed leveling macro again to give me the Z offset. I then changed the SD card with a file I wanted to print, I went to preheat for PLA and the temps started moving up. Good that's working. For about two minutes...it rebooted and it came back. I could move it but every time it reboots as soon as I click the preheat mode. I had had no response to the emails but I have learned that Creality is not good for communication or customer support. Tech Support? Really Their forum is full of complaints. Should have done more research or buy from a vendor that supports its sales. I have started a sales dispute since I had the machine less than 24 hours and the first time powering up it blew up. We shall see how that goes. BUYER BEWARE!!!!!!!!