Dissapointing
pretty pissed with customer service, as well as wasted expensive material on failed prints. not even using multicolor. I WIsh they had said that the Topper wouldnt be shipped until November. I have had all 4 toolheads filament detector / feeders fail * from built up filament backing up, and breaking while removing*. now im spending $200 for 4 replacement pieces of plastic, which should cost me like $2, not $200. I thought it was a good deal, and was impressed from videos I had seen Online. and spent my savings on this machine. only to be let down and wasting hours of my very little free time, trying to fix problems I have with the machine. Very dissapointed, I used my "snaps" for a discount and was unable to use them on a certain purchase and lost them. I really had high hopes for this printer and Went with it instead of bambulabs. but I am not very impressed with the money I wasted. firmware is totally bugged, I constantly get Error Codes popping up on screen, even though I auto level and manual level everytime I print. Need a better slicer interface and other special fillament support. I have 90% fails and 10% success with printing.