My Concerns About Spooky2’s Biofeedback…
My Concerns About Spooky2’s Biofeedback and PMF Coil I recently purchased a Spooky2 device and tested its biofeedback function, which claims to detect and eliminate pathogens using frequency scanning. However, as an electronic engineer with medical training, I found serious flaws in its design and methodology—some of which could even be dangerous. 1. The Problem with Biofeedback Scanning • The device uses unshielded, ungrounded electrode pads (with ~2 meters of exposed cabling) to scan frequencies between 400 kHz and 40 MHz inside the body. • From an engineering standpoint, this setup cannot produce a clean, reliable, or reversible signal—especially at such high frequencies. • Even if it could, body frequencies constantly shift due to emotions, diet, and other factors, making any scan results unreliable. 2. The Dangerous "Kill Strategy" • Spooky2 claims its scan identifies the "20 strongest frequencies" from bacteria, parasites, and pathogens (BPP), then instructs users to kill the strongest ones first. • This approach is medically reckless. o A healthy gut requires 75% beneficial bacteria to suppress harmful pathogens. o If you destroy the good bacteria first, the remaining pathogens can multiply unchecked, leading to: Leaky gut syndrome (where harmful microbes enter the bloodstream). Systemic infections (as pathogens attack organs). Brain barrier disruption (since lactobacilli protect the brain—killing them lets pathogens invade). 3. The PMF Coil’s Ineffectiveness • I also tested their Pulsed Magnetic Field (PMF) coil for knee inflammation. • It uses high frequencies (up to 30 MHz) at an extremely low power output (0.00000013 W). • This energy level is far too weak to have any therapeutic effect. 4. Customer Support Ignored My Warnings • I contacted Spooky2’s customer care, but they dismissed my technical and medical concerns. • Their refusal to address these issues is alarming, given the potential health risks. Conclusion Spooky2’s biofeedback system is scientifically flawed, and its "kill strategy" could harm users’ microbiomes. The PMF coil’s power output is also too low to be effective. Until these issues are resolved, I cannot recommend this device. ________________________________________ The critics (by email) from Spookey 2 support was again totally denial from facts and harassment... What can you expect from Spookey 2 support ? My Spookey 2 plasma generator, the PmF coil output is not working... No support... no offer, nothing. For what is such support good?