Good but not good enough.
Good but not good enough. The install was straight forward and the book was good, but it didn't explain the extra cable for the AMS port since I already had the AMS port. I got the AMS so that I could us the multi-material capability. I made a hood so I could continue using high temp filaments. However, unless you have all high temp filaments configured, when trying to load a high temp filament, the nozzle cools down to 220°C and PC can't load. It should use the configured low temp of the filament programmed and not a hard limit! I have a work around, but this is just poor quality control. You should never assume that a maker is only going to use lower temp filaments because you didn't offer a hood.