Mostly good but problems exit
I am having problems with the 4th toolhead. It will print fine for two or three hours but then gives an error message about not being able to read the toolhead and needing to clean the pogo pins. I will do this but a few hours later it happens again. The pattern repeats itself. This only happens on toolhead 4. At this point since i have had it less than 48 hours wondering if i should return it While the instruction manual is good, perhaps more than one line would be helpful at times to explain why it is requested. For example, why do you move the print head around the edge two or three times. For the most part it was self explanatory but there were times you wondered why You have very limited files to print on your site to choose. There is an online site that you if you can use files from bambu labs files, strip the bambu lab headers so they don't give errors inside orca slicer but it would be easier if this was done inside the program. If you were totally new you may not be aware of other sites where you can get files to print. When bringing up files from your site, it keeps the color information from the file. It would be nice if it could automatically sync or at least gave the option to sync with the color selection on the machine. Also the plastic on the machine flexes too much giving it a cheap feel. The camera for video is almost worthless in the mobile app. It is very jerky. It would almost be better to just take still shots. The machine has potential but it is noisy. I have had 4 3d printers. I would rate Bambu Labs H2C best, snapmaker u1 as second but very close is the Prusa mini (it never gave me any issues but it is much smaller limiting my use), and finally the Ender 3. There is nothing good i can say about Ender unless you want to convince people not to get into 3d printing, then you give them an Ender